Bronkhorst BRIGHT (V2.00 and higher) - Manual (Page 32)

6 | SETTINGS MENU
6.24 Bus settings
When the operating instrument is connected to a bus
system you can change the node address of this
instrument.
From the setup menu select the bus item and press
to enter the bus settings screen.
6.25 Advanced menu
From the advanced menu you can:
o
change sensor filter settings
o
start sensor auto zero procedure
o
start restore instrument data procedure
To enter the advanced menu, select the advanced option
from the settings menu and press
.
6.26 Sensor filter settings
To change the sensor filter settings select the sensor item
from the advanced menu and press
to enter the
sensor filter settings screen.
The sensor filter is split into a dynamic and a static part.
Use the and
button to select the dynamic or static
parameter and press to enter the edit mode.
In the edit mode, use and to change each
character. Press to select the next character.
Press to exit the edit mode without changes.
When the final character is changed, press to confirm
and to exit the edit mode.
6.27 Sensor auto zero
To start the sensor auto zero procedure, select the
autozero item from the advanced menu and press
to
enter.
Press
to select the ‘start auto zero’ option.
SET
SET
SET
SET
SET
9.17.048 Page 32