2 rear panel – Broadata Communications LBC-PSW84 User Manual

Page 7

LBC-PSW84 User’s Manual
Link Bridge

Multi-format Presentation Switch

Broadata Technical Support, (800) 214-0222

+/-: Press these buttons to move up/down under menu
selection or under volume control to adjust audio volume up/
down.

ENTER: Press this button to confirm menu selection

2.2 Rear Panel

1. IR OUT: Connect to the supplied IR Blaster cable for IR signal

transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.

2. IR IN: Connect to the supplied IR Extender cable for IR signal

reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.

3. OUTPUT CAT5e/6/7: Connect to the Receiver unit with a Single

CAT5e/6/7 cable for transmission of all data signals.

4. OUTPUT HDMI: Connect to a HDMI equipped TV/monitor for

display of the HDMI input source signal.

5. OUTPUT COAX: Connect to audio sound equipment such as

speaker or amplifier for audio sound output.

6. OUTPUT AUDIO: Connect to audio sound equipment such as

speaker or amplifier for audio sound output. This audio is
extracted from the video output. The source for this audio is
dependent upon the selected mode from the OSD. If in ‘Auto’
mode then the source audio is derived from the input HDMI
embedded audio. If in ‘EXT’ mode the audio is sourced from
the external input audio.