Bompani BO 210 VB/N - Manual (Page 13)

13
GB InSTRUCTIOnS FOR THE USER
IMPORTAnT nOTICE
THE OPERATIOnS InDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSOnnEL
EXCLUSIVELY, In COnFORMITY WITH THE REGULATIOnS In FORCE.
THE MAnUFACTURInG FIRM REFUSES ALL RESPOnSIBILITY FOR DAMAGES TO PEOPLE,
AnIMALS OR THInGS, RESULTInG FROM THE FAILURE TO COMPLY WITH SUCH PROVISIOnS.
InSTALLATIOn
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 65°C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,
etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig.3, at a distance
of at least 50 mm from the appliance border to the
adjacent walls.
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving a
depression space of at least 10 mm (fig.4).
Fastening the top
Every cook-top is equipped with a special washer
having an adhesive side.
-Remove the racks and burners from the top
-Turn the appliance upside down and lay the
adhesive washer S along the external border of
the glass (fig.5).
-Introduce and place the cook-top in the hole
made in the piece of furniture, then block it with
the V screws of the fastening hooks G (fig.6).
Installation room
This appliance is not provided with a device for
exhausting the products of combustion. Therefore,
it is necessary to discharge these smokes outside.
The room where this appliance is installed
must have a natural air inflow, so as to ensure
a regular gas combustion and room ventilation:
the necessary air volume must not be lower than
20m 3 .
Air must come from permanent openings made on
the room walls that communicate with the outside.
The section of these openings shall correspond to
at least 200 cm 2 .
Gas connection
Make sure that the appliance is adjusted for
the gas type available (see the label under the
appliance). Follow the instructions indicated in the
chapter “gas transformations and adjustments” for
the possible adaptation to different gases.
The appliance must be connected to the gas
system by means of still metal pipes or flexible
steel pipes having continuous walls, in compliance
with the regulations in force.
Gas enters the appliance through a cylindrical
threaded male gas union (1/2”).
The connection must not stress the gas ramp.
Once the installation is over, check the connection
seal with a soapy solution.