Bladez Fitness Fusion GS Indoor Cycle - Manual (Page 19)

19
CONSOLE OVERVIEW
SPECIFICATIONS:
TIME(TMR) 00:00-99:59 Minutes
ODOMETER(IF HAVE) 0.9999 KM or M
SPEED(SPD) 0.0-99.9 KM/H
PULSE”(IF HAVE) 40-240 BPM
DISTANCE(DST) 0.00-999.9 KM
CALORIES(CAL) 0-9999 KCAL
KEY FUNCTION:
1. MODE: Lets you select a particular function.
2. PAUSE: Press to start or stop the functions.
3. SET: Allows you to choose a target value for TIME ,DISTANCE,CALORIES, ODOMETER
& PULSE.
4. RESET: Resets the value to zero.
OPERATION PROCEDURES:
1. AUTO ON/OFF:
• The system will turn on when any button is pressed or when it receives an input from the
speed sensor.
• The processor turns off automatically when the speed sensor has no signal input or no button
has been pressed for more than 4 minutes.
2. HOW TO CHANGE THE SPEED/DISTANCE FUNCTION FROM MILES TO
KILOMETERS:
• After installing the batteries in the console the default distance/speed measurement is in
Miles and is noted by an M on the display in the speed (SPD) and distance (DIST) functions.
• To change the distance/speed to Kilometers press the mode button for 3 seconds. The display
will blink and the distance/speed is now Kilometers.
• Kilometers are noted by a K on the display. To change back to Miles repeat the same procedure.
3. RESET: The unit can be reset by changing the batteries or pressing the RESET button for 3
seconds.
4. HOW TO PRESET TIME, DISTANCE, ODOMETER, PULSE & CALORIES:
• Press the MODE button until the function to be preset is flashing.
• Press the MODE button once the function stops flashing .
• Next, choose the value you want to exercise by pressing the SET button.
• When the speed sensor receives a signal, the monitor will begin to count down.
• It will beep for 10 seconds to indicate the completion of preset workout, press any button to
stop the beeping.
• If data is not preset, functions will count up.