Bladez Fitness T300i Treadmill - Manual (Page 16)

16
To adjust the running belt, stop the treadmill,
then use the 6mm hex wrench and adjust the hex
screw located in the rear end cap. If the running
belt is moving towards the left side, tighten
the left hex screw with a 1/4 turn (clockwise);
if the running belt is moving towards the right
side, tighten the right hex screw with a 1/4 turn
(clockwise); Turn the treadmill on after it has
been adjusted. If you find that the belt has not
moved to the proper position, please repeat the
steps above. Don’t use the treadmill until the
running belt returns to the center position.
The position of running belt might not stay
precisely in the center, it can and will shift
slightly towards the left and right sides, however,
you do not need to adjust the belt if it is not
rubbing against the side rails.
Depending on the usage of the product, please
apply silicon according to the chart to the right.
Use the hex wrench to unscrew the bolt inside
the rear roller. Then pull the belt up and put
some silicon on the center of the board. After
that, adjust the belt to the center of the deck,
then tighten all screws back into place.
When the belt is sliding, please follow the above
method to lubricate the running board.
MAINTENANCE
KGS/LBS Speed Interval
KGS
6KM/hr Below 1 year
6~12KM/hr 6 months
12KM/hr Above 3 months
LBS
4mile/hr Below 1 year
4~8mile/hr 6 months
8mile/hr Above 3 months
Note: This maintenance is intended for household
use. If used for business, it is suggested to
examine the product every other month.
Silicon Chart