Dynex DX-L19-10A - Manual (Page 18)

Changing channel settings
15
Selecting the audio mode
You can select the audio mode for analog channels.
To select the audio mode for analog channels:
• Press MTS/SAP on the remote one or more times. You can select:
• MONO—Select this option if there is noise or static on weak
stereo broadcasts.
• STEREO—Select this option for programs broadcast in
stereo.
• SAP—Select this option to listen to a secondary audio
program, if available.
Note: Mono is automatically selected if the program is broadcast in
mono.
To select an audio track for a digital channel:
• Press MTS/SAP. If an audio track is available, it plays.
Playing TV audio only
You can turn off the picture on your TV and listen to only the program
audio.
To play only the TV audio:
1 Press MENU. The on-screen menu opens.
2 Press or to highlight Setup, then press . The Setup menu
opens.
3 Press or to highlight Audio Only, then press or to
select On.
4 Press EXIT to close the menu.
Notes:
Audio Only works only when the input source is TV and your TV is
receiving a broadcast signal.
To exit Audio Only mode, press any button. When you exit Audio Only
mode, the Audio Only option is automatically reset to Off .
Changing channel settings
Automatically scanning for channels
To auto scan for channels:
1 Press MENU. The on-screen menu opens.
2 Press or to highlight Channel, then press . The Channel
menu opens.
3 Press or to select Air or Cable.
4 Press or to highlight Auto Scan, then press ENTER. A
confirmation box opens.
5 Press or to select Yes, then press ENTER to start the scan. A
progress box shows the progress of the scan.
Parental Controls
DX-L15-L19-L22-10A_08-1840.book Page 15 Saturday, January 24, 2009 7:40 AM