Beisler 739-23-1 Manual - Manual (Page 19)

3. Inserting of material in material clamps
Example: Inserting of a pocket flap
–
Place material clamp 1 onto holder 2.
– Open material clamp
– Place lining material 5 with the right side upwards into the material
clamp.
– Place outside fabric 4 with the right side downwards into the
material clamp.
Both pieces of material must touch the stop. At the edges, they must
be aligned in such a manner that there is the same amount of excess
material to the right as to the left.
–
Press down lever 3.
The material clamp is closed.
Clamping force of material clamps
Depending on the thickness of the material, it might occur that the
material clamps cannot or can only barely be closed.
In this case, the clamping force must be adjusted (see maintenance
instructions).
1-19
2 1 5 4 3