Beisler 1281-4 - Manual (Page 37)

2-11
3.5.1 Presser foot
(max)
30V 15 V
120 00 150 [ms]
SETUP-03
1. Position the cursor on the time of maximum power (left value in lower row)
and press the Plus/Minus key until 150 ms is set. This assures that the
presser foot is lifted safely after seam end.
2. Position the cursor on the value of the holding voltage (upper row, value in
the middle of the display) and press the Plus/Minus key until 15 V is set.
This assures that the magnetic valve for the foot release will not be
overloaded.
3. Position the cursor on the value of the start delay (right edge) and enter
120 ms here. This time is required to assure that the sewing foot rests
safely on the cloth before sewing starts.
4. Position the cursor on both presser foot icons and set them to „Presser
foot up“ like shown in the picture.
5. Press the Special key to leave this page.
6. Check, whether the presser foot is programmed on „up“ on page „PROG
000“, too.
3.5.5 Step motor transportation unit
The motor of the transportation unit is optimized as a factory setting and
should not be modified. Open the corresponding setup page to check the
settings:
SETUP-03 1 2 3 4
0 80
2 8
1
6
10 7
1
8
8
1
80
8
8
8
1
10
JS
KJ
KP
KA
IL
IH 80
8
8
8
1
10