BECKHOFF M1110 - Manual (Page 8)

M1110 Parallel Input / Output Box Beckhoff II/O System
Page 8 of 17 Version 2.1 Date 09.03.93
The following module configurations are possible by jumpers adjustments :
Jumper Field on board M1210_4
Jumper 1 Watchdog on / off
If this jumper is set the ’Watchdog’ function is switched off.
This means if an error is detected the outputs set are not
switched off.
Jumper 2 Latch on / off
The jumper is set according to the standard configuration.
The input signals are read each 6.8 msecs.
Jumper Field on Board M1110_4
Fast Inputs M1110_4 (Interrupt Inputs)
Jumper 3 Fast input II3 :
If jumper connection between port D0.3 and XILINX II3 is
established.
Jumper 4 Fast input II2:
If jumper connection between port D0.2 and XILINX II2 is
established.
Jumper 5 Fast input II1 :
If jumper connection between port D0.1 and XILINX II1 is
established.
Jumper 6 Fast input II0 :
If jumper connection between port D0.0 and XILINX II0 is
established.