BECKHOFF C9900-A172 - Manual (Page 16)

Installation Instructions
Cable sets between receiver and Control Panel
Order number Denomination
C9900-K510 Connection set for CP68xx consisting of:
DVI cable 3 m, USB cable 3 m and power supply
connector
C9900-K514 Connection set for CP78xx consisting of:
DVI cable 3 m, USB cable 3 m and power supply
connector; IP-65 connector at the Control Panel
Connecting cables
The connections are located at the front of the modules and are
documented in Section
Product Description .
Please refer to the respective instruction manuals regarding the
configuration of the connections at the Industrial PC (if a PCI bus
transmitter card is used) and at the Control Panel.
When connecting cables, please adhere to the following order:
• Switch off the Industrial PC
• Disconnect the Industrial PC from the power supply
• Connect all cables at the modules, the Control Panel, and the
devices to be connected
• Ensure that all screw connections (if present) between plug
connectors and sockets are tight!
• Connect the DVI/USB extension modules with the 24 V power
supply. The PCI bus transmitter card is supplied via the Industrial
PC.
• Reconnect all devices to the power supply.
CAT 7 cable with RJ 45
connector Two standard CAT 7 cables with RJ 45 connector are used for the
connections between transmitter module and receiver module, and
transmitter card and receiver module.
DVI/USB extension C9900-A17x 15