BECKHOFF CP69xx - Manual (Page 14)

Installation Instructions
Fitting the cable
Wiring Fit the cables for the power supply of the Control Panel, using the included
material for assembling the connectors.
Material for assembling the connectors
Material for assembling the
connectors
Plug connector 5-pole
Stain relief housing with lacing cord
Assembling the connectors
Conductive cross-section The connector is specified for 16 A and can lift conductive cross-sections
until 1.5 mm
2 .
Fitting the connector to the
cable So the connector is fitted to the cable:
1. Strip insulation from the cable ends (Length of stripped conductor
is 8 - 9 mm).
2. Screw together the cable ends in the 5-pole plug connector in
accordance with wiring diagram.
Applying the strain relief
Thread the lacing cord into that
lower part of the stain relief housing.
Putting in the plug
connector
Put the plug connector into that
lower part of the stain relief housing.
Tighten the lacing cord and pinch off
the plastic strap.
Fixing the upper part of the
stain relief housing
Fix the upper part of the stain relief
housing by snapping it onto the
lower part.
CP69xx 13