BECKHOFF CP6608 - Manual (Page 12)

Installation Instructions
Fitting the cable
Wiring Fit the cables for the power supply of the Control Panel, using the included
material for assembling the connectors.
Cable Cross Sections
Note cable cross sections,
avoid voltage drop! For the connection of the power supply, wiring with a cable-cross-section
of 1.5 mm
2 must be used.
With bigger distances between voltage source and Control Panel, you take
the voltage drop as a function of the cable-cross-section as well as voltage
fluctuations of your distribution voltage into account, so that is secured that
the voltage doesn't fall under 22 V at the power supply.
Insert Fuse The power supply must be protected with maximum 16 A.
Material for assembling the connector
Material for assembling the
connector
Plug connector 5-pole
Stain relief housing with lacing cord
Assembling the connector
Fitting the connector to the
cable So the connector is fitted to the cable:
1. Strip insulation from the cable ends (Length of stripped conductor
is 8 - 9 mm).
2. Screw together the cable ends in the 5-pole plug connector in
accordance with wiring diagram.
Applying the strain relief
Thread the lacing cord into that
lower part of the stain relief housing.
Putting in the plug
connector
Put the plug connector into that
lower part of the stain relief housing.
Tighten the lacing cord and pinch off
the plastic strap.
Fixing the upper part of the
stain relief housing
Fix the upper part of the stain relief
housing by snapping it onto the
lower part.
10 CP6608