BECKHOFF CU8810-0000 - Manual (Page 12)

Operating Instructions
PWRDVI 2
PWRDVI2 Function
on DVI Input Port 1 is activated
off DVI Input Port 1 is deactivated
OUT-LEVEL The next switch 3 is used to set the back termination for the output level.
The use of back terminations is highly recommended for best signal
integrity.
i
Note
This switch is set to off by factory and should only be changed after
consultation with the Beckhoff Support.
OUT-LEVEL Function
on No back termination is used
off Back termination is used
Switch 5 and 6
Switch 5 and 6 are paired to select the source for the DDC signal for
DVI Input Port 0. The DCC signal from the selected port is send to the
device connected to DVI Input Port 0.
The following table shows the possible selections.
5 6 Function
off off The DDC-channel from DVI Input Port 0 (X40) is connected to
DDC-channel to DVI Output Port 0 (X50)
on off The DDC-channel from DVI Input Port 0 (X40) is connected to
DDC-channel to DVI Output Port 1 (X51)
off on The DDC-channel from DVI Input Port 0 (X40) is connected to
DDC-channel to DVI Output Port 2 (X52)
on on The DDC-channel from DVI Input Port 0 (X40) is connected to
DDC-channel to DVI Output Port 3 (X53)
Switch 7 and 8
Switch 7 and 8 are paired to select the source for the DDC signal for
DVI Input Port 1. The DCC signal from the selected port is send to the
device connected to DVI Input Port 1.
The following table shows the possible selections.
7 8 Function
off off The DDC-channel from DVI Input Port 1 (X41) is connected to
DDC-channel to DVI Output Port 0 (X50)
on off The DDC-channel from DVI Input Port 1 (X41) is connected to
DDC-channel to DVI Output Port 1 (X51)
off on The DDC-channel from DVI Input Port 1 (X41) is connected to
DDC-channel to DVI Output Port 2 (X52)
on on The DDC-channel from DVI Input Port 1 (X41) is connected to
DDC-channel to DVI Output Port 3 (X53)
10 CU8810-0000