BECKHOFF C5210 - Manual (Page 28)

Troubleshooting
6 Troubleshooting
Fault
Cause Procedure
Nothing happens after the Industrial
PC has been switched on No power supply to the Industrial
PC
Other cause Check power supply cable
Call Beckhoff Service
The Industrial PC does not boot
fully Setup settings are incorrect
Other cause
Check the setup settings
Call Beckhoff Service
Computer boots, software starts,
but control does not operate
correctly Cause of the fault is either in the
software or in parts of the plant
outside the Industrial PC Call the manufacturer of the
machine or the software
Memory device access error Faulty device Call Beckhoff Service
The Industrial PC functions only
partially or only part of the time, e.g.
no or dark picture, but disk drive
responds when switching on Defective components in the
Industrial PC Call Beckhoff Service
26 C5210