Becker EDITION TRAFFIC ASSIST PRO 7929 TMC - Manual (Page 23)

23
General operations
Unit bracket
The unit holder on the Traffic Assist Pro
can be attached directly to the
windshield or the instrument panel of
your vehicle (see also page 23).
The TMC receiver is integrated in the
unit holder and has connections for an
external power supply, a TMC antenna,
stereo earphones and a radio mute
function for navigation announcements.
1 “Rotate” fastening screw
2 Bracket/TMC receiver
3 Suction cup lever
4 Suction cup
5 “Horizontal” fastening screw
6 “Vertical” fastening screw
Fitting the unit bracket
The unit bracket can be secured directly
to the inside of the windscreen or to the
dashboard.
Note:
The Traffic Assist Pro and unit bracket
must not be exposed to long periods of
direct sunlight. Temperatures inside the
vehicle of +70 C and higher may damage
parts of the bracket.
2
3
4
5
6
1
Note:
Fasten the unit holder such that your
field of vision is not impaired when the
Traffic Assist Pro is installed and ensu-
re that the unit is outside the deploy-
ment area of the airbag.
Ensure that the electrical connection
cable does not hamper you from acces-
sing the vehicle's controls.
Also ensure that there is enough space
to easily slide the Traffic Assist Pro
back out of the bracket.
Clean the mounting area on the wind-
screen or dashboard so that it is clean
and free of grease. Do not use smearing,
soapy cleaning agents, otherwise this
may affect how it sticks to the dash-
board.