Baja Motorsports X250 - Manual (Page 33)

30
TROUBLESHOOTING
Ignition System Check
1. Remove the spark plug and reattach it to the spark plug lead.
2. Turn ignition key to the “RUN” position. Slide the engine stop switch to
the “Run” position. Push the electric button “START “(grey button). If the
ignition system is operating properly, a blue spark should jump across the
spark plug gap. If there is no spark, take your machine to your service center.
COMPLAINT: Engine stalls
1. Make sure there is enough fuel in the fuel tank.
2. Check to see that the spark plug is not fouled. Remove the spark plug and
clean it. Replace it, if necessary.
3. Make sure the fuel valve is not clogged, and the fuel tank is not clogged,
either.
4. Check the idle speed. If necessary, adjust it using a tachometer. The correct
idle speed is 1400~1600 r/min.
5. Make sure the air filter is clean.
WARNING
Performing the spark test improperly could be hazardous.
You could get a high voltage electrical shock if you are not familiar with this
procedure.
Do not perform this check if you are not familiar with the procedure. Do not
point the spark plug near the spark plug hole during this test. Do not do this
test if you have a heart condition or wear a pacemaker. Do not perform this
test is any near any open fuel containers for near fuel which has spilled on
the ground, on the engine, or any part of the dirt bike.