Baja Motorsports X250 - Manual (Page 14)

11
OPERATION
SWITCHES ON RIGHT HANDLEBAR
Ignition switch
The ignition switch is Located on the right handlebar.
When switch is turned to “ ” (off) position, the engine will not start. If
engine is running and (off) button is pushed the engine will turn off.
When switch is turned to “ ” (on) position, the engine can start when
ignition key is also at (on) position and electric start button is
depressed, or when starting by the kick lever.
ON button
OFF button
Electric Start button
ENGINE BREAK-IN
The first 10 hours of operation should be considered the “Break-in” period
and special attention shall be paid to the following points:
1. Do not throttle past half throttle during the first 10 hours of operation.
Fluctuate the throttle during this period to break in engine components.
Do not put excessive load on engine by climbing steep hills or having
fast starts.
2. Warm up engine 3-5 minutes prior to operation so all components are
lubricated sufficiently. Failure to allow engine to warm up could cause
damage to engine.