BAFO BF-6200 - Manual (Page 16)

USB 2.0 to IDE 2.5” hard disk Enclosure User’s Manual 16
8. FAQ
Q : After driver installed, there is no new hard disk model name show at “Disk
Drivers” of “Device Manager” or “Universal Serial Bus controllers” does not
have “USB Mass Storage Device” appear.
A: Adjust jumper of hard disk to “Cable Select” or other setting and try again.
Q: If a brand new hard disk has been installed at enclosure. It shows “USB Mass
Storage Device” in “Universal Serial Bus controllers”, but there is not any new
hard disk at “Disk drivers”.
A: Please FDISK and FORMAT hard disk.
Q: When transferring file and system hang-up.
A: Set “Never” at “Turn Off hard disk” of “Power Management” of “Device Manager”.
9. Disclaimer
Information in this document is subject to change without notice. The manufacturer
does not make any representations or warranties (implied or otherwise) regarding the
accuracy and completeness of this document and shall in no event be liable for any
loss of profit or any other commercial damage, including but not limited to special,
incidental, consequential, or other damages.
No part of this document may be reproduced or transmitted in any form by any means,
electronic or mechanical, including photocopying, recording or information recording
and retrieval systems without the express written permission of the manufacturer.
All brand names and product names used in this document are trademarks, or
registered trademarks of their respective holders.
10. FCC Statement
This device generates and uses radio frequency and may cause interference to radio
and television reception if not installed and used properly. This has been tested and
found to comply with the limits of a Class B computing device in accordance with the
specifications in Part 15 of FCC Rules. These specifications are designed to provide
reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If this
device does cause harmful interference to radio or television reception, which can be
determined by plugging the device in and out, the user can try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the computer into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. Consult the
dealer or an experienced radio/TV technician for help.