Calibrating the sensor pen, B-64 – Baby Lock Crescendo (BLCR) Instruction and Reference Guide User Manual
Page 66

USING THE SENSOR PEN
B-64
Calibrating the Sensor Pen
Before using the sensor pen for the first time be
sure to calibrate it to the screen. Doing so allows
the machine to learn the position you usually hold
a pen.
Hold the sensor pen at a comfortable angle and
then calibrate the machine according to the
procedure below.
Be sure to keep the sensor pen at the same angle
while calibrating the first and second points.
a
Press .
→ The settings screen appears.
b
Display page 6 of the settings screen.
c
Press
after connecting the sensor
pen to the machine.
→ The Sensor Function Calibration screen appears.
d
First, touch the green dot marking on the
needle plate using the sensor pen.
*
Touch on the needle plate cover.
a Needle plate cover
*
A beep will sound and the a will change to red. (If
you cannot hear the beep, check that the volume
setting on page 4/10 of your settings is 1 or higher.)
*
Press
to redo the first point by starting over
from step
c
.