beautypg.com

Introduction, Caution, About the circular attachment – Baby Lock Symphony (BLSY) Instruction and Reference Guide Addendum User Manual

Page 4: Included accessories

background image

2

INTRODUCTION

This Addendum provides additional information not described in the Instruction and Reference Guide.

Refer to these instructions after first reading the Instruction and Reference Guide provided with your sewing

machine.

USING THE CIRCULAR ATTACHMENT TO SEW

PATTERNS IN A CIRCLE

About the Circular Attachment

This device can sew circular patterns that graduate out at 5mm intervals, ranging from 30mm to 130mm in

radius* when the center needle position is selected. The device is set to the left of the needle on your sewing

machine. Utility and decorative stitches can both be sewn using this device.
*

Radius= Distance from center of circle to any point on the circle.

Included Accessories

Note

• You cannot use any decorative stitch with side feeding or stitches with a width over 7.0 mm. Before sewing on your

project, be sure to sew trial stitches and check the sewing results. If stitches that cannot be used are sewn, the pattern
may become misaligned. For a list of stitches that cannot be used, refer to the table “LIST OF STITCHES THAT CANNOT
BE USED WITH THE CIRCULAR ATTACHMENT” located on page 17.

CAUTION

• Special care is required for the pivot pin; neglectful treatment may cause injury. Young children should be

supervised to ensure that they do not play with the attachment. When attachment is not in use, always
keep the pivot pin in the indicator to avoid its loss.

1

4

Conversion Chart

5

mm (f)

inch

130

5 3/16

120

4 3/4

110

4 3/8

100

4

2

3

90

3 1/2

6

80

3 3/16

70

2 3/4

60

2 3/8

50

2

40

3/2

30

13/16

No.

Part Name

Part Code

1

Circular Attachment

a Indicator
b Handle/Flips Up
c Release button
d Setting position for pivot pin
e Scale

-

2

Pivot Pin

XE6016-001

3

Attachment Screw
(2pcs. one is extra)

XE6022-001

4

Template

f Radius of circle in mm
g Angular lines listed in degrees

starting at 0 with 5 degree
intervals

h Center

XE6024-001

5

Braiding Foot

XE5680-001

6

Cording Foot

XA6871-001

No.

Part Name

Part Code