B.C. Time Recorders Amano TCX 21 - Manual (Page 5)

Page 3
Power Connection
Before connecting power, verify that the AC outlet voltage falls in the
range of 100-240 Volts AC and that the power cord and plug are
appropriate for your AC source. Plug the power cord into a properly
grounded 120 or 240 Volt wall outlet.
Wall Mounting
Note: Mounting screw locations should be marked on the wall. Do
not insert a drill bit through the mounting holes of the back plate
when drilling holes.
1. Disconnect the power cord from the power source.
2. Unlock and remove the cover.
3. Locate the teardrop mounting hole and the two 1/4” mounting holes
in the back plate.
4. Approximate the final location of the clock. Insert one #10 wood
screw or equivalent into the wall 1-1/2” (38 mm) from the top center
location of the clock.
5. Hang the clock on the screw using the teardop mounting hole.
6. Secure the clock to the wall by inserting screws through the bottom
two mounting holes.
7. Reconnect the power cord to the power source.
8. Re-install the cover and secure.