Ddns – Aviosys 9255Pro User Manual
Page 25
- 25-
Ref#92550806002
Leakage: This will turn off power output if leakage over 3mA as set " Shutdown " .
Beeper: This will enable or disable the beep on the device.
CGI Command: This will enable or disable the http commands for the 9255Pro.
Delay Switch: The Delay switch will delay the device to activate the command to
a designated amount of time. If set to 10 seconds after commands during
scheduler or http commands are sent there will be a 10 second delay.
Device Name: Select the name for the device here, and this name will be used
for registering the device on IP Service.
Firmware: Will provide information on the current firmware for the device
DDNS
The DDNS Setup allows the user to setup the 9255Pro with a DDNS server. This
way instead of having to remember long IP Addresses, the user now can easily
use a WWW link to connect to the device. This also is a good solution for users
to have a dynamic IP Address where the IP continually changes and is not
constant.
Note: We recommend using free services like
for this portion.
The device may react differently to other ddns services.