Avionics Innovations AM/FM Receiver P/N: 15001-00 - Manual (Page 5)

Avionics Innovations
AI-AM/FM RECEIVER Operation And Installation Manual
ST (STEREO) (FM)
During auto seek, tuning with the SEEK > and < SEEK buttons, all receivable stations are tuned in. "ST" indicator appears on
disc-play only whenever an actual stereo broadcast station is being received.
6. SEEK > and < SEEK
: TUNE ∨∨ and TUNE ∧∧
These buttons have multiple functions as follows:
Tune
∨∨ and Tune ∧∧ (RADIO)
During radio operation, press to seek and tune only receivable stations. Pressing the Tune ∧∧ tunes (upwards) to the next
receivable station. Pressing the Tune
∨∨
tunes (downward) to the lower receivable station.
7. MANUAL TUNING: (RADIO)
TUNE
∨∨ and TUNE ∧∧
During radio operation, these buttons may be used for manual rapid tuning, by digits. Also, very helpful whenever the desired
station is too weak to tune in with the SEEK > and < SEEK buttons.
Press either the Tune
∧∧ and Tune ∨∨ button once or repeatedly to change displayed frequency by digits. Press and HOLD button
to change rapidly.
8. MUTE BUTTON
The MUTE button is used to silence the radio audio output, press it again to return to the previous audio level.
9. STORE
This feature is especially helpful while traveling cross-country through unfamiliar radio broadcasting territory.
1. Press and HOLD STORE button (for at least 3 seconds) until displayed frequency starts to change, then release.
Once activated, the system automatically scans upscale seeking receivable stations starting from
the frequency currently being displayed, and stores 6 receivable stations in the memory preset.
2. Once the scanning stops, "P1" (pre-set 1) is tuned in.
Note: STORE memory programming will erase any previous preset program and will affect current band selection
only. Repeat procedure on other FM bands as desired.
LISTENING TO THE RADIO
OPERATION
1. Press BAND button to turn the power on.
2. Select desired radio frequency band, also with the BAND
button, Selection appears on display ( FM1 / FM2 / FM3).
3. While viewing display, select desired station with the SEEK or TUNE buttons.
4. Adjust VOLUME / BALANCE / BASS / TREBLE to desired level.
NOTES: When an FM stereo station is tuned in, the "ST" indicator will appear on display.
Revision A July 23. 1998
Page 4