Avionics Innovations AM/FM Receiver P/N: 15001-00 User Manual
Page 4
Avionics Innovations
AI-AM/FM RECEIVER Operation And Installation Manual
OPERATION OF CONTROLS
ALL BUTTON NAMES ARE IN BOLD TYPE
1. FM BAND BUTTON
(RADIO ON / BAND SELECT)
This button functions as a POWER switch for the radio and also as radio frequency band select switch.
Press BAND button to turn on the radio, during radio operation, press BAND button once or repeatedly to change bands
(FM1/FM2/FM3).
2.
and
+
AUDIO LEVEL CONTROL BUTTONS
These
and
+
buttons normally function as the Volume control. Also used for adjusting the Bass, Treble, Balance and Fader
audio levels, after selecting mode with SEL button. If no adjustment is made within 5 seconds after mode is displayed, it reverts to
"VOLUME". (also see item re: SEL button).
VOLUME: Press the
+
button to increase, or
-
to decrease sound level.
BASS: While "BAS" is being displayed, press the + button to increase, or press
to decrease the bass level.
TREBLE: While "TRE" is being displayed, press the + button to increase, or press
to decrease level. BALANCE: While
"BAL" is being displayed, press the + or
button to level balance of speakers left to right.
FADER: While "FAD" is being displayed, press the + or
button to select center or rear audio position, front option not
available.
3. POWER OFF BUTTON
Press this button to turn the power OFF. To turn on the power to the radio, press BAND button .
4. SEL (AUDIO ADJUST MODE) BUTTON
Press SEL button to select Volume / Bass / Treble / Balance / Fader adjustment mode. Each time button is pressed, accessed
selection is displayed.
While selection is being displayed, press (within 5 seconds) either
-
or + buttons to adjust level as desired ).
Note: "VOLUME" is the priority mode which overrides SEL button, allowing control over sound level at any time without having
to enter SEL. Also, note that although not displayed, 5 seconds after the last selection or adjustment is made, mode reverts to
"VOLUME".
5. STATION PRESET BUTTONS (
1-6
)
These buttons have a dual function, depending on how long they are held in the depressed position Use these buttons to memorize
or recall up to 18 FM selections.
SETTING PRESET SELECTIONS
1.Select desired band FM1/FM2/FM3 with the BAND select button.
2. Tune in desired radio station with < SEEK or SEEK > buttons or TUNE
∧∧
and TUNE
∨∨
b
uttons.
3.Press and HOLD one of the PRESET buttons
1-6
for at least 3 seconds. Audio is muted momentarily -
when
audio resumes, and preset number appears on display, station has been entered in the memory.
4. Repeat steps 2 and 3 for remaining PRESET buttons.
5. Repeat steps 1, 2, 3 and 4 for each band, to memorize a total of 15 stations.
RECALLING PRESET STATIONS
Press desired button number momentarily (for less than 2 seconds) Selection number appears on display.
Revision A July 23. 1998
Page 3