Avionics Innovations DMP-200 (MP3 Player) Installation Manual - Manual (Page 6)

DMP-200 INSTALLATION MANUAL PAGE 6 OF 18
P/N DMP8012-00 REV E
2.0 Mechanical
2.1 Specifications
The DMP-200 is fully contained within a 2-inch (5cm) high standard mount
enclosure.
Height: 2.00 in. (5.1 cm)
Width: 6.25 in. (15.8 cm)
Depth*: 4.34 in. (11.0 cm)
Weight: 1.10 lb (499 g) (With Mounting Tray)
Tray depth behind panel. Connector shell protrudes 0.25” (0.64 cm)
beyond system enclosure.
2.2 Mounting Considerations
The DMP-200 should be installed in a normally heated, pressurized section of the aircraft;
however the unit contains no moving parts and does not require special vibration isolation.
The unit may be mounted in an auxiliary area of the instrument panel, in a pedestal, or
anywhere in the aircraft cabin outside of the cockpit. In a severe vibration environment,
the unit should
not be mounted vertically with the front panel facing down, to ensure that
the memory card does not accidentally vibrate loose. Otherwise, the DMP-200 may be
installed in any orientation and at any angle.
3.0 Electrical
3.1 General
The following guidelines should be used when installing the DMP-200:
♦
All wiring to be installed in accordance with FAA AC-4313-1A, Chapter 11, Sect. 2
♦
All non-audio wiring to be MIL-W-22759 unless otherwise specified
♦
All audio wiring to be MIL-C-27500 shielded unless otherwise specified
3.2 Connection to Aircraft Power
The DMP-200 accepts a wide range of input voltage directly, without the need for
converters or configuration changes.
Minimum input: 10.0 VDC (1.0 Amp @ 10.0 VDC)
Maximum input: 35.0 VDC (0.1 Amp @ 35 VDC)
Nominal input: 14 VDC / 0.30 Amp
28 VDC / 0.15 Amp
Aircraft power must be supplied via a 1 Amp resettable circuit breaker.