Avionics Innovations DMP-200 (MP3 Player) Installation Manual - Manual (Page 14)

DMP-200 INSTALLATION MANUAL PAGE 14 OF 18
P/N DMP8012-00 REV E
1. Press and hold the button while turning on power. Release the button when the DMP-200
display first lights up.
2. The DMP-200 will be in SETUP mode. Advance through all the setup items as described
above, and set the options to match your installation. Do NOT select the setup item: “Set
LOUD volume level” unless you have a memory card installed that has been prepared
using the supplied CardPrep software.
3. Turn the knob to display the SETUP item labeled “Test Ext Outputs”. Press the button
repeatedly to cycle through the various external outputs. Confirm that all attached
equipment (annunciators, relays, chime generators, etc) perform as intended.
4. Turn the knob to display the SETUP item labeled “Text Ext Inputs”. For each input
(triggers and external Pause/Play), activate the external contact closure and confirm the
corresponding display on the DMP-200.
To verify the audio outputs, you must prepare a memory card using CardPrep software before
powering up the DMP-200. Power up the DMP-200 normally (do not enter SETUP mode), and
select a track for playback to create an audio signal for testing.