Avalon Firestyles DVS Fireplace-1997 to 2000 - Manual (Page 10)

P AGE 10
I
NSTALLATION
(C
ONT
.)
- For Qualified Installers Only!
Facing Requirements
¥ The combustible area above the facing must not protrude more than 3/4" from the facing. If it
does, it is considered a mantel and must meet the mantel requirements listed in this manual.
6" Min.
(both sides)
Non-combustible Facing
The fireplace requires a concrete
board (or other non-combustible)
extending from the header to the
floor and to the framing members on
both sides. Do not use sheetrock,
plywood or other combustible
material.
Arch Face
Rectangular Face
12" Min.
Header
Bottom of
Faceplate
32" Discovery & Rosario
30" FPX Arch & Rect.
31-5/8" Heritage Bay
30-1/2" Salish Bay
33-7/8" Cambridge
21-9/16" Discovery & Rosario
22" FPX Arch & Rect.
21-1/2" Heritage Bay & Cambridge
22-1/2" Salish Bay
acing Over 1" Thick
¥ If the facing material
is over 1" thick (e.g.
brick, river rock),
install the facing
around the perimeter
of the face. You may
wish to make a
facing support (see
the illustration to the
right). If using an
arch face, you may
wish to order the
optional set-up face:
Arch Set-Up Face
Part # 98500697
Make a facing support using
2x4Õs. It should be 1/8Ó larger
than the finished face. NOTE:
The bottom of the face is 1-1/2Ó
above the base of the fireplace.
1-1/2Ó
Note: if using a brick hearth, the fireplace will need to be raised to accommodate the 1-1/2Ó gap betwen the
face and the base of the fireplace. For 2-1/2Ó thick brick this works out to approximately 1-1/8Ó.
The brick facing must meet the same requirements
listed in ÒFacing RequirementsÓ above.
Center
Line
Rectangular Faces
Use the optional Arch
Set-Up Face available
from Travis
Industries.
Arch Faces
Face Sizing:
WIDTH:
32" Lopi Discovery Face
32" Avalon Avanti Face
30" FPX 32 Arch Face
30" FPX 32 Rect. Face
HEIGHT:
21-9/16" Lopi Discovery Face
21-9/16" Avalon Avanti Face
22" FPX 32 Arch Face
22" FPX 32 Rect. Face