Installation, Steps for finalizing the installation – Avalon Firestyles Cypress User Manual

Page 24

Installation

(for qualified installers only)

4121130

100-01311

Steps for Finalizing the Installation

1. Remove the glass (see page 26).

NOTE:

If using propane (LP) convert the appliance prior to installing the logs, driftwood, or stone

set.

2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected

once it enters the firebox, ensuring gas does not build up.

3. Make sure the accent light works correctly.

NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).

4. Install the four AA batteries (included in the owner’s pack) into battery holder (see the illustration below). The AA

batteries act as a power backup in case the household (AC) power goes out. Install the 9v battery (included in
the owner’s pack) into control panel light assembly (see the illustration below). Velcro is provided to secure the
9v battery.

5. Install the media (logs, driftwood, or stone set - see page 28).

6. Replace the glass.

7. Start the heater.

8. Leak test all gas joints.

AA Battery

Swing the control

cover down to

access the batteries.

Battery

Holder

AA Battery Tray

AA Battery

Battery Holder for

Control Panel Lights

Battery