ATI Audio MX200 - Manual (Page 9)

Audio Technologies Inc. 856-719-9900 [email protected] www. audio.com
The WA100 is a 400mA supply. A MXS100 or MX200 or MX200C draws about
160mA, a XPS100 draws 100mA and a XPS200 draws 70mA; therefore, one
mixer could be combined with two XPS100s or three XPS200s on a single power
supply module. Any combination of NANOAMPS which add up to less than
400mA can be powered by a single WA100 supply.
BATTERY
POWER
Several battery power systems are available for field powering of the MXS100,
MX200C or MX200. The BBU100-1 houses four 9V alkaline or lithium batteries
and will power the MXS100 for three to five hours.
The PPA-1 rechargeable gel-cell pack powers a MXS100 for approximately five
hours and can be recharged overnight with the included dual-mode charger. The
PPA-1 is capable of approximately 500 charge-discharge cycles.
The DCA100 DC to DC Converter accepts inputs from 6 to 18 VDC and outputs
24VDC to operate a mixer from 6.0 or 7.2V camcorder Ni-Cd, belt-pack Ni-Cd
packs, automotive 12V or 12.0 to 14.4 V NP-1 batteries. The DCA100 requires a
standard 4 pin XLR input connector from the battery source (pin 4 positive, pin 1
ground). Battery clips (Hawk-Woods Co. # NPA - XLR) are available for NP-1
type 13.2V NiMH batteries, which can power a MXS100 thru a DCA100 for up to
10 hours.
The BBU100-1, PPA-1 and DCA100 can all mount directly to the underside of the
NANOAMP case or slip into the quick-change slide mounts provided with the
PROK-1 protection kit or the ABAG-1 carry case. A NP-1 type battery and a
spare can be Velcro to the inside of the carrying case.
INSTALLATION
UNPACKING
Inspect the equipment. Shake it to see if anything is rattling around inside. If
there is any visible damage to the unit or to the box it came in, contact the factory
but do not return anything to ATI without prior authorization and shipping
instructions. It may be necessary to have the shipping company inspect the unit
and the box at your location. Count the pieces! Don't throw out the boxes and
packing material until you are sure you have everything that is coming to you.
The XPS100 and XPS200 come with an audio cable, P/N20612-2, a DC cable,
P/N20602-1, and an instruction book. The MXS100 comes with an instruction
book and a mating 2.5mm T-S plug for the CUE input. The MX200 and MX200C
only come with an instruction book. Mixers need either their own separately
ordered WA100 power supply, a optional battery supply, a DC Converter or
a DC cable, P/N20602-1 to share the supply of another NANOAMP.