ATI Audio MX200 - Manual (Page 11)

Audio Technologies Inc. 856-719-9900 [email protected] www. audio.com
OUTPUT
LEVEL,
-­‐10
to
+8dBm
If a different output level at 0VU meter indication is desired, drive the output to
the desired output level at 1kHz as indicated by an external audio voltmeter
connected across the output line and readjust METER CAL-LEFT and METER
CAL-RIGHT trimpots for 0VU meter indications. Note that the MIC output level (if
used) will track the changes made to the LINE output.
LIMITER
THRESHOLD
-­‐
MXS100,
MX200C
To increase the limiter action (by lowering the threshold) rotate the LIMITER
ADJUST trimpot clockwise, to soften the limiter action rotate the pot CCW.
RACK
MOUNTING
The amplifiers may be rack mounted one, two, or three across in a standard EIA
19" rack and will require only 1 3/4" of vertical space. Rack mount kit P/N20604-
501 mounts a single unit, P/N20604-502 mounts two units and P/N20604-503
mounts three units. Each kit provides a different size pair of rack mounting
brackets and one or two horizontal joiner plates, P/N 20580-1, each with four 4-
40 X 5/16" oval head screws. The joiner plates mount into tapped holes on the
bottom of two side-by-side units, using the supplied screws, while the rack mount
brackets mount under the existing 6-32 cover securing screws on the front sides
of the units.
DESK
MOUNTS
Single desk mounting kits consist of a pair of angled base plates that mount
under the lower front and rear cover screws of a single unit, to raise and to tilt it
for easy desk use. In addition, one or more sets of vertical stacking plates,
mounting to the upper front and rear cover screws of the bottom unit, allow
multiple units to be stacked. Several units can be desk mounted side-by-side and
even stacked side-by-side using horizontal joiner kits together with mounting
base and stacker kits. P/N20617-501 is the angled base kit. P/N20617-502 is the
base plus one stacker kit (two high). P/N20617-503 is the base plus two stackers
(three high). P/N20617-504 is the stacker kit by itself and P/N20604-504 is a
horizontal joiner kit.
PROK-­‐1
PROTECTION
PLATES
and
ABAG-­‐1
FIELD
CARRY
BAG
The Protection Plates PROK-1 (also included as part of the ABAG-1 Field Carry
Bag) are mounted to the sides of the MXS100 by removing the four cover
mounting screws (one side at a time) and replacing them through the mating
holes in the Protection Plate. The Plate should mount with its overhang below the
mixer case and the battery case slide bracket below and toward the mixer.