ATI Audio MX200 User Manual
Page 3
Audio Technologies Inc. 856-719-9900 [email protected] www.
audio.com
DESCRIPTION
MXS100
STEREO
FIELD
MIXER
Three XLR inputs with plug programmable phantom power and front panel
MIC/LINE switches drive low noise instrumentation preamplifiers with a wide
range of internally selectable gains to accommodate either high output wireless
or low output boom microphones. Front panel switches activate individual two
pole LO-CUT filters to block bumps, thumps and wind noise.
Center-detent PAN pots feed the stereo mix busses along with a switched TEST
TONE oscillator and a momentary switched SLATE microphone to easily mark
takes. Bright, intense LED bargraph VU meters monitor the line level outputs and
are easily viewed even in bright sunlight. A LIMIT indicator and switch shows
peaks and controls limiter action. The MXS100 provides high level active XLR
stereo line outputs to drive either balanced or unbalanced external loads of 600
ohms or higher. Rear panel switches individually select microphone or line output
levels. A stereo TAPE OUT jack provides an isolated -10dBu for an external
recorder.
A front panel headphone switch selects either stereo program (L/R) or mono-
summed program with cue (L+R/Q) as an input to the stereo headphone
amplifier. A stereo TAPE IN jack routes an external -10dBu monitoring signal to
the headphone amplifiers in place of the stereo program feed. A recessed,
thumbnail operated headphone level control minimizes panel clutter and once
set, tracks the MASTER output. An external CUE input jack or a pre-fader cue
from any of the three inputs may be jumper plug programmed to the headphone
cue circuit. The expansion buss input allows interconnection of two MXS100s or
the addition of one or more companion XPS100 Mic Expanders or XPS200
Stereo Line Expanders.
All panel controls, internal adjustments, and jumper plugs are clearly labeled.
MX200,
MX200C
STEREO
STUDIO
MIXERS
The MX200 and MX200C Stereo Studio Mixers are also three input stereo mixers
with front panel selection of microphone or line input levels. Phantom power is
internally jumper plug programmable to any microphone input. Detented Pan
Pots feed fader output to the stereo mix busses. A close tracking VCA stereo
MASTER level control feeds stereo high-level line output stages. The outputs
comfortably drive either balanced or unbalanced output loads of 600 ohms or
greater. Bright LED VU meters and a stereo headphone amplifier monitor the
program outputs. XLR output connectors are standard. A rear panel Expander
input allows interconnection of two mixers or the addition of one or more
companion XPS100 or XPS200 Expanders. The MX200C adds a switched low
distortion compressor/limiter and peak indicating LED to the basic MX200 mixer
features.