ATI Audio DDA416/WC106 - Manual (Page 7)

7
DDA‐416/WC106 Manual
DIGITAL ERRORS
Indicates four error conditions encountered in digital signals as an aid to troubleshooting: Bi-
Phase/Parity, Validity, Non-Linear PCM and DTS-CD Signal. It displays the conditions for the
channel selected with the SOURCE MONITOR AND CONTROL.
INPUT RE-CLOCKING
Indicates Input Re-Clocking On or Off. Press the RE-CLOCKING button to toggle the setting. Note
that this function applies only to INPUT 1 to 4. Settings are individual for either AES 1, AES 2, AES
3 or AES 4 inputs, and are memorized and retained through power outages.
MODE
Indicates whether incoming AES/EBU input signal is Pro or Consumer (S/PDIF) mode for the input
selected.
INPUT EQ
Enables automatic input equalization. LOCKED indicates input data is present and acceptable.
ENABLED indicates equalization is applied. Press the INPUT EQ button to enable automatic
equalization. Settings are individual for all inputs, and are memorized and retained through power
outages.
SOURCE MONITOR & CONTROL
Selects the input source to be monitored or controlled. Pressing the button cycles through, INPUT
1 (AES 1), INPUT 2 (AES 2), INPUT3 (AES 3), INPUT4 (AES 4), AES SYNC IN (AES Sync) or
WORD CLOCK INPUT (WCLK).
FRONT PANEL LOCK
The Front Panel Lock protects your front panel settings. Press and hold the FRONT PANEL LOCK button until
the LED in the SOURCE MONITOR & CONTROL field stops flashing, to lock all the front panel controls. Press
and hold again to unlock.
REAR PANEL CONNECTIONS AND SWITCHES
AES/EBU Input 1
Provides a balanced, transformer isolated 110 ohm AES/EBU input that may be routed to Outputs
1 – 4, 5 – 8, 9 – 12 and/or 13 – 16 via the configuration DIP switches. This input may also be
routed to the six BNC outputs as either AES or derived Word Clock.