3 device-category, 4 diag-service, 3 device-category 5.2.4 diag-service – Artesyn ViewCheck on ATCA-9405 Installation and Use (May 2014) User Manual
Page 57
Commands Execution
ViewCheck on ATCA-9405 Installation and Use (6806800S51C)
57
]]>]]>
5.2.3
device-category
device-category
command allows to configure the available device categories.
Syntax
device-category
Expected Output
The CLI prompt will show the device category that you have selected
.
5.2.4
diag-service
diag-service
command allows to start/stop/restart/status the diagnostics service.
Syntax for CLI
diag-service operation
This command is valid only in CLI.
This manual is related to the following products:
- ViewCheck on ATCA-7370 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (November 2014) ViewCheck on ATCA-F140 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (September 2014) ViewCheck on ATCA-7470/7475 Installation and Use (May 2014) ViewCheck on ATCA-F140 Installation and Use (November 2014) ViewCheck on ATCA-9405 Installation and Use (September 2014) ViewCheck on ATCA-7480 Installation and Use (April 2015) ViewCheck on ATCA-9405 Installation and Use (November 2014) ViewCheck on PrAMC-7311 Installation and Use (May 2014) ViewCheck on ATCA-7370 Installation and Use (April 2014) ViewCheck on ATCA-F140 Installation and Use (April 2014)