Artesyn ViewCheck on ATCA-9405 Installation and Use (May 2014) - Manual (Page 34)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51C) 34
sh /opt/ssf/etc/config/S99SsfBsfRun.sh start/stop/restart
4.4 ViewCheck Service OS Image
The ViewCheck Service OS Image enables you to boot into ViewCheck specific OS and execute
the OOSD tests. The ViewCheck service is not completely dependent on the blade BBS
environment. For compatibility purpose, it may use the same OS or Kernel variant that are used
by the blade BBS service. For ATCA-9405 SP, the ViewCheck service OS is created with PNE 4.1
as the OS. For 9405 PP the OOSD image is build from cavium SDK. The 9405 PP OOSD image is
packaged along with 9405 SP OOSD image. So there is a single ViewCheck OS image for ATCA-
9405 blade.
The ViewCheck service OS along with the ViewCheck RPM, test suites, and test procedures are
distributed as an ISO file that contains:
 ViewCheck OS as Ram Disk image that can be Net bootable
The following table provides details of the files that are distributed as part of this image once
the ViewCheck service OS is installed.
You need to stop the BSF services, before performing uninstallation using below script.
/opt/ssf/etc/config/S99SsfBsfRun.sh stop
The order of removal of RPMs is a reverse procedure to that of installation.
Table 4-2 ViewCheck Service OS Image Files on SP and PP
File Name Remarks
diagnostics-RELEASE-
BUILD.windriver4.1.linux.atca940
5sp.gz
Net bootable Ram Disk image with
ViewCheck RPM, Orion License RPM, and BSF
services package.
ViewCheck OOS image for PP with ViewCheck RPM
and BSF service packages.