Artesyn RTM ATCA-F140 Installation and Use (September 2014) - Manual (Page 38)

Functional Description
RTM-ATCA-F140 Installation and Use (6806800M97G) 38
4.4.5 BCM8727 Status
The PCMULK, PCDRLK, PLOSB and LASI signals from each BCM8727 port are connected to the
RTM FPGA to allow them to be monitored by software. The PLOSB and LASI signals can also
generate an interrupt to the front-blade. Refer to
Chapter 4, FPGA, on page 46 for further
details.
4.4.6 SFP+ Connection
The SFP+ cage accepts industry standard SFP+ optical modules. The SFP+ cage is backwards
compatible with 1 GB optical or copper SFP modules. Refer to the ATCA-F140 Installation and
Use Manual for a list of SFP devices tested with this product. The SFP+ connector assignment
for the 10 Gbps serial interface is described in
Table 4-6 .
4.4.6.1 I2C Bus
The SFP+ I2C bus signals (I2C_SDA and I2C_SCL) from each SFP+ site are individually
connected to the corresponding BCM8727 which includes a mechanism to allow access to the
port through the phy management channel.
Table 4-6 SFP+ Connector Pin Assignment
Pin Signal Pin Signal
1 GND 11 GND
2 TX_FAULT 12 RX-
3 TX_DISABLE 13 RX+
4 I2C_SDA 14 GND
5 I2C_SCL 15 VCCr (+3.3 V)
6 MOD_ABS 16 VCCt (+3.3 V)
7 RS0 17 GND
8 LOS 18 TX+
9 RS1 19 TX-
10 GND 20 GND