Artesyn RTM ATCA-F140 Installation and Use (September 2014) - Manual (Page 21)

Chapter 2
RTM-ATCA-F140 Installation and Use (6806800M97G) 21
Hardware Preparation and Installation
2.1 Overview
 Inspect the shipment and unpack the RTM.
 Make sure environmental and power requirements are met.
 Install the RTM.
2.2 Unpacking and Inspecting the RTM
The shelf should provide minimum airflow to the RTM slot according to the class B.4
requirements of the CP-TA Inter-operability document AdvancedTCA Book 1.1. This includes
the following:
 2.0 cfm at 25 °C ambient temperature
 2.8 cfm at 40 °C ambient temperature
 4.4 cfm at 55 °C ambient temperature
Shipment Inspection
To inspect the shipment, perform the following steps:
1. Verify that you have received all items of your shipment:
 Printed Quick Start Guide and Safety Notes Summary

RTM-ATCA-F140
Damage of Circuits
 Electrostatic discharge and incorrect installation and removal of the blade can damage
circuits or shorten its life.
 Before touching the blade or electronic components, make sure that you are working in
an ESD-safe environment.