Artesyn MVME2500 VxWorks 6.8 User Guide (April 2014) - Manual (Page 12)

Booting VxWorks
MVME2500 VxWorks 6.8 User Guide (6806800L66C) 12
setenv serverip 10.130.101.216
setenv gatewayip 10.130.101.254
setenv netmask 255.255.255.0
3. Set the VxWorks boot image file name.
setenv vxbootfile
vxWorks-2020.st
setenv vxbootfile vxWorks-2010.st
4. Set the VxWorks bootline arguments.
setenv vxbootargs 'motetsec(0,0)10.130.101.216:vxWorks
h=10.130.101.216 e=10.130.101.206:ffffff00 u=vxworks
pw=vxworks f=0x80’
Parameters description:
motetsec(0,0)
: Ethernet interface 0 on cpu 0
10.130.101.216
: Host Machine IP
10.130.101.206
: Board IP
ffffff00
: Netmask
u=vxworks
: Username on host machine
p=vxworks
: Password for the above user in host machine
f=0x80
: File Transfer Protocol (FTP)
5. Set the VxWorks network boot command.
setenv vxboot 'tftpboot $vxbootfile && setenv bootargs
$vxbootargs && bootvx
'
6. Save your current environmental variables.
saveenv
7. To boot VxWorks through network, execute the following command:
run vxboot
For sample output, refer Appendix A, Network Boot, on page 27 .