Artesyn MVME2500 VxWorks 6.8 AMP User Guide (August 2014) - Manual (Page 13)

Booting VxWorks
MVME2500 VxWorks 6.8 AMP User Guide (6806800M27B) 13
Example: tip "dev=/ttyMsd0#tag=green". For more information refer the
tip utility documentation.
For sample output of Vxworks booting on Core 1 through network , refer Appendix
A, VxWorks Booting on Core 1 .
2.3 Disk Boot
2.3.1 Prerequisites
You should have:
 Serial Advanced Technology Attachment (SATA) hard disk with ext2 file system loaded,
and VxWorks image loaded to the ext2 file system
2.3.2 Booting Procedure
To boot VxWorks AMP using disk, perform the following steps:
1. Power up the MVME2500 board.
By default, it provides the U-Boot prompt.
2. Set the environmental variables at the U-Boot prompt.
setenv ipaddr
setenv serverip
setenv gatewayip
setenv netmask
Example:
setenv ipaddr 10.130.101.206
setenv serverip 10.130.101.216
setenv gatewayip 10.130.101.254
setenv netmask 255.255.255.0
3. Set the VxWorks boot image file name.
setenv vxbootfile
vxWorks_00.st