Artesyn MVME2500 VxWorks 6.8 AMP User Guide (August 2014) - Manual (Page 12)

Booting VxWorks
MVME2500 VxWorks 6.8 AMP User Guide (6806800M27B) 12
setenv gatewayip 10.130.101.254
setenv netmask 255.255.255.0
3. Set the VxWorks boot image file name.
setenv vxbootfile
vxWorks_00.st
4. Set the VxWorks bootline arguments.
setenv vxbootargs 'motetsec(0,0)10.130.101.216:vxWorks
h=10.130.101.216 e=10.130.101.206:ffffff00 u=vxworks
pw=vxworks f=0x80’
Parameters description:
motetsec(0,0)
: ethernet interface 0 on cpu 0
10.130.101.216
: Host Machine IP
10.130.101.206
: Board IP
ffffff00
: Netmask
u=vxworks
: Username on host machine
p=vxworks
: Password for the above user in host machine
f=0x80
: File Transfer Protocol (FTP)
5. Set the VxWorks network boot command.
setenv vxboot 'tftpboot $vxbootfile && setenv bootargs
$vxbootargs && bootvx
'
6. Save your current environmental variables.
saveenv
7. Boot VxWorks on Core 0 through network .
run vxboot
This will boot the VxWorks on Core 0 only.
For sample output of Vxworks booting on Core 0 through network , refer
Appendix
A, VxWorks Booting on Core 0
8. Boot VxWorks Image on Core 1, execute wrload command.
Example: wrload "-file /vxWorks -cpu 1"
To access the Core1 Console use the tip utility.