Artesyn ATCA-7350 - Integrating with Workbench User Guide (September 2014) - Manual (Page 7)

ATCA-7350 - Integrating with Workbench User Guide (6806800H90D) 7
About this Manual
Overview of Contents
This manual provides an introduction for building the Linux kernel and root file system for an
ATCA-7350 with Wind River PNE2.0 using Workbench. The Workbench Linux Support Package
(LSP) layer delivered as part of this release should be used for the same. This manual however
does not claim to provide complete working instructions on Wind River PNE2.0.
This manual is divided into the following chapter and appendices.
 Building Kernel and Root File System Images describes the set up of the kernel and root file
system with Wind River PNE 2.0.
 Appendix A, Packaging describes files in board support package.
 Appendix B, Utilities describes copying of files for installation purpose.
 Appendix C, Related Documentation lists the related documents of ATCA-7350.
Abbreviations
This document uses the following abbreviations:
Abbreviation Definition
BSP Board Support Package
DRBD Distributed Replicated Block Device
LHC Link Health Check
LSP Linux Support Package
PNE-Linux Platform Network Equipment Linux