Building kernel and root file system images, 1 overview, 2 prerequisites – Artesyn ATCA-7350 - Integrating with Workbench User Guide (September 2014) User Manual
Page 11: 3 project setup, 1 overview 1.2 prerequisites 1.3 project setup, Prerequisites, Project setup, Chapter 1
Chapter 1
ATCA-7350 - Integrating with Workbench User Guide (6806800H90D)
11
Building Kernel and Root File System Images
1.1
Overview
This section describes how to setup and create Kernel and root file system, with Wind River PNE
2.0, that is suitable to use on an ATCA-7350 blade.
1.2
Prerequisites
The local RedHat Linux (version 4 or above) system should have the following software
installed:
Wind River PNE2.0 Service Pack 4 (PNE2.04) toolchain
Wind River Workbench 3.0.
To integrate the Workbench with ATCA-7350:
extract the ATCA-7350 BBS release 1.1 build 1.1.2 to the /home directory
extract
file to the /home/wind directory. This directory is used to pick layers. You should have
read and write permissions for this directory.
After extracting the bsp.tar.bz2 file the following directory structure is created.
–
/home/wind/bsp/custom_layer/templates/board
–
/home/wind/bsp/custom_layer/templates/dist
–
/home/wind/bsp/custom_layer/templates/packages
Appendix A, Packaging, on page 21
, for more information of the Linux Support Package
(LSP) directory structure and contents.
1.3
Project Setup
To setup a project in the Workbench.
1. Login as a non-root user.
2. Validate that the following line is appended in the User Privilege Section section
of the /etc/sudoers file.