Argox PA-20 Portable Data Collectors User Manual - Manual (Page 16)

12
2.4 Installing, Replacing and Charging Batteries
Wrong use of batteries might cause serious damage to the terminal or to the cradle. In order to
avoid damage, it is very important to take notice of the instructions.
Caution:

Insert a fully-charged battery pack before use of the terminal.

Never remove the main batteries while the terminal is turned on.
Doing so may lose data in the terminal.

Use only recommended batteries.
When other batteries are used, defects or other problems can occur. Before
installing (new) batteries, please make sure you are using the recommended
batteries.

Use the right charger for batteries.
The rechargeable battery pack form Argox can be charged in the cradle when
either it is in the terminal or alone in the charging slot in the back of the cradle.

The life of a battery pack is limited, and charging a battery pack
causes it to gradually lose its ability to maintain a charge. If your
battery pack requires frequent charging, it probably means it is time
to purchase a new one.

Strictly follow the instructions for installing, charging, and removing
the batteries.
The products are not warranted for damage, defects, malfunction, or loss of
data, resulting from incorrect use of batteries.
Required batteries:
The terminal needs both main battery and backup battery for operation.
Main Battery
Terminal: Rechargeable 3.7V 1950mAh Li-Polymer Battery
Gun type: Rechargeable 3.7V
5000mAh Li-lon Battery