Argox A Series - Manual (Page 46)

A Series User’s Manual
91
Printer Terminal/Host
Pin 2- RxData ……… TxData
Pin 3- TxData ……… RxData
Pin 5- Ground ……… Ground
In general, as long as the data quantity is not too large and you
use Xon/Xoff as flow control, it will be problem free.
Baud rate:
2400, 4800, 9600(default), 19200, 38400,
57600, 115200 bauds .(programmable by
command)
Data format: always 8 data bits, 1 start bit and 1 stop bit.
Parity: always non parity
Handshaking: XON/XOFF as well as CTS/RTS (hardware flow
control).
If you run an application with the bundled printer driver under
Windows and use the serial port, you should check the above
parameters and set the flow control to "Xon/Xoff "or "hardware".
A Series User’s Manual
92
Appendix I - Installing the Extension Card
Extension Card designated for all optional extension modules.
For example, RTC card and Add-on card.
Install the extension card into the printer as follows:
1. Turn off the printer power.
2. Remove the top cover.
3. Release the two screws at the bottom of the base housing.