Argox A Series User Manual
Page 36
A Series User’s Manual
71
LED Indicators: Power and Ready LEDs blink alternately
Power LED Ready LED
ON
OFF
OFF
ON
Possible Problems
Solutions
Remarks
Ribbon out
Supply the ribbon roll
Ribbon jam
Recover the jam
Ribbon sensor error Replace ribbon
sensor
Not applicable
to direct
thermal type.
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON
ON
OFF
ON
Possible Problems
Solutions
Remarks
Serial IO error
Check the baud rate Serial interface
only
Memory full
Add the extension
RAM(flash memory
card)
Cutter failed, or jam
at cutter
Check the cutter
Recover the jam
Occurs only when
installing or setting
the cutter
Hardware error
Call for service
A Series User’s Manual
72
LED Indicators: Only the Ready LED blinks
Power LED Ready LED
ON
ON
ON
OFF
Possible Problems
Solutions
Remarks
Print head too hot
Printing will stop until
the print head cools to
an acceptable printing
temperature. When it
does, the printer will
automatically resume
operation.
Printer head module
uncovered
Make sure that printer
head module has
been covered.