Zilog Z16FMC2 - Manual (Page 5)

Opto-Isolated USB SmartCable
User Manual
UM019506-0814 Page 5 of 8
2. Select Install from a list or specific location (Advanced) , then click Next . If the
Windows Logo testing dialog appears, select Continue Anyway .
3. Select Search for the best driver in these locations and Include this location in
search: , then locate and click the following directory:
\device drivers\USB\x32
4. Click Next . After the appropriate driver information has been found, click Next a sec-
ond time.
5. Click Finish to complete the installation.
Connecting to the Target Board
Attach one end of the six-conductor ribbon cable to the SmartCable six-pin DBG connec-
tor; see Figure 2. Attach the free end of the ribbon cable to the connector on the target
board. Ensure that pin 1 on the ribbon cable (indicated by the dark stripe) is aligned with
pin 1 on the target connector. For more information on connecting the USB SmartCable to
your target board, refer to the
Z8 Encore! Design for Debug Technical Note (TN0036) .
A half-twist in the ribbon cable between the Zilog-manufactured target board
and the Opto-Isolated USB SmartCable is normal.
Figure 2. Connecting the Six-Conductor Ribbon
Cable to the Opto-Isolated USB SmartCable
Note: