beautypg.com

Zilog ZEPIR0BA User Manual

Page 15

background image

UM026001-0413

Evaluation Board Hardware Functions

ZMOTION

®

Detection Module II Evaluation Kit

User Manual

11

Table 1. ZMOTION Detection Module II Functions

Feature

Operational Mode (SW1—MODE)

Evaluation
Board Name

Function
Type

Hardware Mode

Serial Mode

System Reset

RESET (SW2) Push Button

Reset ZDM II by momentarily interrupting power.

Ambient Light
Threshold

AMBIENT (R6) Potentiometer

Sets the amount of ambient light required to prohibit the
MOTION LED from activating. Turn clockwise to
increase the amount of light required.

Sensitivity

SENS (R3)

Potentiometer

Controls the ZMOTION
Detection Module II’s sensi-
tivity to motion. It provides
an adjustable voltage
between 0 V and 1.8 V to
the SBC’s TXD/SNS input.
Turn clockwise to increase
sensitivity.

No effect. Use the serial
interface to control sensitiv-
ity.

/MD Output
Delay Time

DELAY (R4)

Potentiometer

Controls the amount of time
that the MOTION LED is
activated after motion has
been detected. Turn clock-
wise to increase the time.

No effect. Use the serial
interface to control /MD
output delay time.

SBC State

STATE (J11)

Jumper

Places ZDM II into a low power sleep mode.

CDS Enable

CDS ENABLE
(J7)

Jumper

When this jumper is installed, the CDS Photo Cell is
used. When this jumper is not installed, you can control
the LG signal from the prototype area.

OCD Interface DBG INTER-

FACE (J9)

6-pin Header

This 6-pin header provides the interface to the USB
SmartCable (debugger) when developing software on
ZDM II.

This manual is related to the following products: