Zilog EZ80F91AZA - Manual (Page 29)

UM007518-1211 Data Persistence Configuration
Zilog Real-Time Kernel: eZ80
®
CPU
User Manual
19
MAX_SEMAPHORESH 20 Specifies the maximum number of semaphores
that can be created at a time. If the system does
not require semaphores, then this macro is set
to 0 (zero).
MAX_TIMERSH 20 Specifies the maximum number of software tim-
ers that can be created at a time. If the system
does not require software timers, then this
macro is set to 0 (zero).
MAX_PARTITIONSH 20 Specifies the maximum number of memory par-
titions that can be created at a time. If the sys-
tem does not require partitions, then this macro
is set to 0 (zero).
MAX_REGIONSH 20 Specifies the maximum number of regions that
can be created at a time. If the system does not
require regions, then this macro is set to 0
(zero).
MAX_REGIONS_TABH 250 Specifies the maximum number of allocations
that can be made within the regions at any given
time.
RZK_MAX_DCBH 25 Specifies the maximum number of entries that
can be made in the device control block.
RZK_DEVICE_DRIVERH 1 Defined if RZK drivers are used.
RZK_STACK_SIZEH 2048 Specifies the size of stack required for kernel’s
idle thread.
RZK_SYSTIMERSTACK_SIZEH 2048 Specifies the size of stack required for the RZK
timer thread.
RZK_SYSTICKS_INSECH 100 Specifies the number of ticks per second for the
system.*
RZK_DEVTICKS_PERSYSTICKH 1 Specifies the number of device ticks per system
tick.*
SYSTEM_CLOCKH 48000000L Specifies the processor’s clock speed.*
HWTIMER_TO_USE 0 Specifies the hardware timer to be used as the
source for the RZK system; valid values range
from 0–3.
Table 12. Default Debug Priority Inheritance Values for the RZK_Conf.c File (Continued)
RZK Macro Default Value Description
Note: *Refer to the Zilog Real-Time Kernel Reference Manual (RM0006) and its appendix about Interrupt Handling to
configure the RZK timer.