Zilog ZUSBOPTS - Manual (Page 14)

MC MDS Module Description UM019206-1011
8
Z8FMC16100 Series Motor Control Development Kit
User Manual
UART Controller
PA5_TXD 36 O Transmit Data—This signal is the transmit output
from the UART and IrDA.
PA4_RXD 35 I Receive Data—This signal is the receiver input for
the UART and IrDA.
PA6_CTS 33 I Clear To Send signal from the receiving device that
is ready to receive data.
PA3_TXDE 45 O Driver Enable—This signal allows automatic con-
trol of external RS-485 drivers. The DE signal
ensures that an external RS-485 driver is enabled
when data is transmitted by the UART.
Analog
ANA0_M
ANA1_M
ANA2_M
PB3_ANA3_OPOUT
ANA4
ANA5
ANA6
ANA7 1
2
3
6
7
8
11
12 I Analog Input. These signals are inputs to the ADC.
PA2_CINP 15 I Comparator positive input.
ANA4 7 I Comparator negative input.
PA7_COUT 34 O Comparator output.
PA1_OP_CN 4 I Operational amplifier positive input.
PA0_OPINN 5 I Operational amplifier negative input.
PB3_ANA3_OPOUT 6 O Operational amplifier output.
RESET-PWM Fault
RESET/FAULT0 53 I/O RESET input pin generates a Reset or PWM fault
when asserted (driven Low). The function selection
is determined by the FLTSEL bit of the User
Options Bits at MCU Program Memory Address
0001h, and the FAULTSEL bit in the MCU Reset
Status and Control Register.
Power Supply
VCC_3.3 V 9, 55, 59 3.3 VDC Power.
GND 10, 19, 30,
39, 46, 48,
56 Ground.
Table 1. Connector JP2 Signal Descriptions (Continued)
Signal Pin Number
Direction
(with respect
to MCU)
Description