Establish a connection with the pc, D the establish a connection with the pc – Zilog S3F80QB User Manual
Page 7

UM026703-1014
Establish a Connection with the PC
S3F80QB Development Kit
User Manual
4
1. Prior to connecting the S3F80QB Development Board to your development PC,
download ZDS II for S3 Family devices version 5.2.0 (or later) from the
Download-
able Software
category in the
2. When the download is complete, unzip the file to your hard drive. Double-click the
installation file named ZDS II – S3_
tions.
Establish a Connection with the PC
Observe the following procedure to connect the S3 Flash ISP and S3F80QB Development
Board to your PC.
Disconnect or turn off the power to the S3F80QB Development Board before connecting
or disconnecting the S3 Flash ISP.
1. Connect the Mini-B side of the USB A (male)-to-Mini-B cable to the S3 Flash ISP.
Connect the other end of this cable to the PC, as shown in Figure 2.
2. Install the S3 Flash ISP driver as described in
Appendix B. Install the S3 Flash ISP
3. Connect the 10p 5x2 ribbon cable to the S3 Flash ISP, as shown in Figure 3.
Figure 2. Connect the S3 Flash ISP to the Development PC
Caution: