Kit contents, Supported host environments, Supported target environments – Zilog S3F80P5 User Manual
Page 5: Installing the s3 flash isp driver
UM026602-0515
P R E L I M I N A R Y
Kit Contents
S3 Flash In-System Programmer
User Manual
2
This document describes how to install the S3 Flash In-System Programmer device and its
associated drivers. After the device is connected and the drivers and library are installed,
you can proceed with the developing and debugging of your code and hardware as
described in the documentation that is applicable to your development board.
Kit Contents
The S3 Flash In-System Programmer Kit contains the following items:
•
S3 Flash In-System Programmer
•
USB cable with Type-A and Type Mini-B connectors
•
10-wire ribbon cable
•
S3 Flash In-System Programmer Kit hardcopy insert (FL0165)
Supported Host Environments
The S3 Flash In-System Programmer operates in the following environments:
•
A host PC running ZDS II – S3 version 5.2.0 or later
•
Windows 7 (32/64-bit), Windows Vista (32/64-bit), Windows XP (32-bit) operating
systems, or Windows 8 (32/64-bit).
•
One USB full-speed port on the host computer or a USB hub connected to the host com-
puter
Supported Target Environments
The S3 Flash In-System Programmer supports the following targets:
•
Any S3 Family development board
•
Any other development or application board with any S3 Family device
Installing the S3 Flash ISP Driver
To install drivers for the S3 Flash In-System Programmer, see